Hydraulic Solutions can meet all your servicing needs. We offer:

• Service of all hydraulic components
• Large test bench for pumps (500 hp)
• Repair and re-manufacture (if required) cylinders and cylinder components
• Cylinder pull down bench, accommodating cylinders up to 10 m long
• Testing and repair of all kinds of hydraulic and pneumatic valves
• Manufacture of pins and bushes.

Our mobile troubleshooting and breakdown service can meet you onsite, and we also have a mobile hose service.

On Site Capabilities

• Machining: Lathes x 2, maximum 3m between centres, 660mm over bed, 105mm spindle bore
• Machining: Milling
• 500hp Pump test bench
• Motor load test bench
• 200bar, 11 l/min on test bench for smaller motors, valves, cylinders
• Cylinder strip down bench, 3 tonne wrench capable, 10m length
• Off line filtration to 3 micron, water removal.
• Crimper up to 2″ (-32) hose
• Hoses stocked on site: up to 6 wire 1.5 inch, large range of hose ends stocked.
• Seals stocked on site: up to 4” cylinder, common styles.
• Accumulator recharging- common fittings including most hammers.